Werbung
Verfügbare Sprachen
Verfügbare Sprachen
POOL CARE
Observing the correct water composition is the single most important factor to increase the life span and maintain the appearance of the film material, as
well as clear, pure and healthy water.
The most important thing in water care is a correctly adjusted pH value. This is the prerequisite for an optimal effect of the water care products used.
Measure the pH value immediately after filling your pool with the chlorine and pH value tester. The value determined (comparison measurement)
should be between 7.2 and 7.4. The pH value should always be in this range. The measurement should be taken at least 1 - 2 times per week.
The pH value is changed by factors such as water temperature, bathing frequency, dirt ingress and other environmental influences. Please also note
the information in our pool care instructions:
http://www.steinbach.at/poolpflege
End of the season
At the end of the swimming pool season, the water level below the skimmer or the inlet nozzle must be lowered.
By adding a winter agent and covering with a winter cover, you only need to fill the pool up to the middle of the skimmer with fresh water
again in spring.
In addition, the connecting hoses to the filter system must be dismantled. The filter system or the filter pump is drained by opening the drain plugs. Filter
systems that are located outdoors must be stored in a frost-proof room in winter.
We recommend winter storage only when the water temperature is below 12°C. Damage caused
by frost is not covered by warranty!
012620_012622_012624_012621_012623_012625_v_2110
012620_012622_012624_012621_012623_012625_v_2110
en
EN
de
061205_v1911
061205_v191 1
DE
15
31
Werbung
