Werbung
Verfügbare Sprachen
Verfügbare Sprachen
− After each operation treat bare metal parts with an
environment-compatible biodegradable spray oil to
protect them against corrosion.
− the cutting roller and shaving plate are expendable parts,
though with normal use and correct adjustment they
have a service life of many years.
Replace worn and damaged single parts as a whole
−
set to prevent any unbalance.
Before each fault elimination:
− Switch off device.
− Wait for standstill of the device.
− Pull out mains plug.
Fault
Motor does not start
Motor hums but does not
start
Shredding material is not
drawn into the shredder
Shredding material not cut
cleanly
Device starts but blocks
under as slight load and
switches off via protective
motor switch.
In case of further faults or inquiries please contact your local dealer.
18
Operational faults
Possible cause
No power supply
Mains cable defective
Machine overloaded (motor protection)
Cutting roller blocked
Capacitor faulty
The cutting roller is running in reverse.
Wrong switch position
Shredding material caught in funnel
Shredding material too soft or wet
Cutting roller worn
Fixed counter blade not adequately
adjusted
Extension cable too long or cross-
section to small.
Socket too far from mains supply and
cross-section of mains cable too small
Remedy
Check fuses
have these checked (electrician)
Allow the device to cool down.
Press the
1. reset button (motor protection)
2. green button
to restart.
Switch off the device.
Turn the direction of rotation selector switch into position
. Switch on device until the jam has been cleared.
Switch device off again. Turn back the direction of
rotation selector switch to position .
Bring machine to manufacturer or authorised workshop
for repair.
Switch off device and switch over direction of rotation
selector switch.
Switch off device. Switch the direction of rotation
selector switch into position
release the material to be shredded, remove any foreign
matter.
Switch off device again. To continue work, place the
direction of rotation selector switch back into position .
Push down with a branch and shred
Adjust fixed counter blade as described under „adjusting
the fixed counter blade". In case of severe wear, replace
cutting roller.
Adjust fixed counter blade
Extension cable at least 1.5 mm², maximum 25 m long.
If a longer cable is used, minimum cross-section 2.5
mm².
. Switch on device to
Werbung
