Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
RotoForce-3 on RotoPol-31
RotoForce-3 on
RotoPol-21/22/25 or on
Rotopol-1/-2/-V
RotoForce-3
Instruction Manual
n Lift off the cap covering the supporting hole placed on the top
of the RotoPol-31 cabinet with a knife.
n Likewise remove the two caps covering the fastening screws
on the left-hand side of the RotoPol cabinet.
n Remove the black stop ring from the supporting column of
RotoForce-3.
n Lead the supporting column of RotoForce-3 down into the
supporting hole in RotoPol-31. Turn the column until the
cross pin in the bottom of the column gets caught by the
guiding slots inside RotoPol-31.
n Tighten the two fastening screws on the left-hand side of the
RotoPol-31 cabinet and cover the screws again with the two
caps.
n Place two working tables of equal height at a distance about
half the length of RotoPol. Place RotoPol between the tables,
carefully balancing the machine, until it stands firmly
between the tables.
A RotoPol machine equipped with a RotoForce weights over 50 kg!
n RotoPol-21/-22/-25: Remove the cap covering the supporting
hole between the two turntables.
RotoPol-1/-2/-V: The transportation case for RotoPol
includes a printed template. Punch out the pre-cast hole in
RotoPol with a round-headed hammer as follows: strike the
circle on the template marked RotoForce-3 with a firm blow.
Remove the template when the hole opens.
n Lead the supporting column of RotoForce-3 down into the
supporting hole of RotoPol.
n Turn the column until the cross pin in the bottom of the
column gets caught by the guiding slots inside RotoPol.
n Fasten the nut and washer from the transportation box
tightly under the column of RotoForce-3 below RotoPol.
Take care!
3
Werbung
