Werbung
26a
36
If the machine is fi tted with the beading system for
Tubeless tyres integrated in the slidings of the turn-
table, follow the procedure set out below.
Beading with Tubeless device on turntable:
Proced as follows:
A. If possible lock the wheel from inside. Outside
locking reduces effi ciency of the bead seater.
B. Connect the infl ation hose to the valve stem.
C. Lift the tire with both hands so that upper bead is
sealed to the rim edge (Fig. 26a).
D. Press the infl ation pedal down swiftly. The top
bead is already sealed by the lifting motion. The
air from the bead seater jets will rebound into the
bottom sidewall driving it into place and creating
a seal.
E. Complete infl ation as described at the beginning
of this section.
WHEN OPERATING THE BEAD SEATER AND
INFLATOR IT IS MANDATORY TO WEAR EAR
PROTECTORS AND SAFETY GLASSES TO
PREVENT CONTAMINATION FROM NOISE, DUST
AND CHIPS BLOWN BY THE AIR JETS.
Werbung
