Werbung
3
4
5
14
4
5
7
3
5
2
6
1
For models with the infl ating device built into the column
also:
F.
Connect the diameter 8 hose (12, Fig.2a), from the
column to the infl ating pedal tap as illustrated.
Note: For hose connections, see the
pneumatic diagrams supplied in the Spare Parts
Manual.
G.
Refi t the column base guard "1" and all of the parts
previously removed.
H.
Secure the tyre changer to the fl oor.
2.3 Transporting the machine at site
Suitable lifting cables and lifting facilities or a fork-lift
truck should be used for transporting the machine.
Always mind the centre of gravity of the machine.
Fig. 3 Transport using a fork-lift truck
• For transport of the machine secure machine
post and mounting arm against moving out of
place.
• Tilt the machine slightly.
• Drive the fork-lift truck below.
• Lower the machine on the fork-lift truck and
position such that it will not turn over during
transport (mind the centre of gravity of the
machine).
Fig. 4 Transport using lifting facilities
• For transport of the machine secure machine
post and mounting arm against moving out of
place.
• Position the lifting cables or other suitable lifting
facilities on the machine as illustrated in Fig. 4.
• When lifting the machine, make sure that the
lifting cables are properly positioned (mind the
centre of gravity of the machine) and that the
machine does not tip over.
2.4 Fitting the bead breaker
Fig. 5 Fitting the bead breaker
1 Bead breaker. 2 Hook. 3 Spring. 4 Bead breaker
support. 5 Holes in bead breaker and support. 6 Pin.
7 Locking circlip.
Place the bead breaker (Fig. 5, Item 1) inside
the support (Item 4). The holes (Item 5) of bead
breaker and support must match.
Lightly grease pin (Item 6). Fix the bead breaker
(Item 1) on support (Item 4) with pin (Item 6) and the
clip (Item 7).
Attach spring (Item 3) to the hook on the frame and
connect it to the hook (Item 2) on the bead breaker.
Werbung
