ABL Wallbox eM4 Single Bedienungsanleitung/Sicherheitshinweise Seite 25

ATTENTION
RFID card not readable
If the antenna of your RFID card is blocked or damaged, the card cannot be recognised.
Remove the RFID card from its protective cover or card holder to register at the RFID reader.
x
Do not make any modifications to the RFID card: The card must never be perforated, stamped, folded,
x
have stickers attached, or otherwise be manipulated mechanically.
Make sure that the RFID card corresponds to a standard that is supported by the wallbox. You can
x
find further information in the comprehensive installation manual.
7 Check the status indicator of the wallbox
(display: 1 cycle).
After a request by the vehicle, the charging
x
operation in progress is displayed dynami-
cally via the blue status indicator.
When the charging operation is complete,
x
it is automatically terminated by the
vehicle, and the status indicator lights up
solid blue.
NOTE
No charging request or interruption of the charging operation
The status indicator also lights up solid blue under the following circumstances:
The charging operation has not yet been started or has been paused by the vehicle.
x
The charging operation has not yet been started or has been paused by the internal load manage-
x
ment. You can find further information in the comprehensive installation manual.
8 Unplug the charging connector from the
vehicle's charging inlet and close it.
|
Charging procedure 25