Reiner jetStamp 790 Bedienungsanleitung Seite 89

jetStamp 790/790 MP
6. Troubleshooting
6.1. Operating and fault messages
Display
Dark display/
Lines in the display
CHARGE BATTERY
NO IMPRINT POSSIBLE
EMPTY BATTERY
NO IMPRINT POSSIBLE
IMPRINT BLOCKED
WRONG STATION
ERROR 04
ERROR 09
6.2. Reset button
Carrying out a device reset causes various settings to be lost, e.g. date and time or the
battery capacity display. The jetStamp 790 must then be inserted into the charging station
for about three hours in order to synchronise the battery capacity display.
After a total discharge of the battery, strange characters can appear on the display during
charging. Pressing the reset button
Fault cause
Display fault
Batteries are discharged
Battery is empty
Print triggering is blocked
Incorrect charging station
Memory error
- Sensor or motor faulty
- Print carriage blocked
3
resolves this issue.
Fault correction
Press the Reset button
f
Charged batteries
f
Charge batteries
f
Press [QUIT]
f
Press [QUIT]
f
Press [QUIT]
f
Press [QUIT]
f
GB
4
87