Reiner jetStamp 790 Bedienungsanleitung Seite 59

jetStamp 790/790 MP
1. Preparation and Set-up
1.1. Set-up
Only connect the device to the PC after the 790 PCset easy software has been installed
(see "Installing 790 PCset easy-Software", page 63).
The batteries must be completely charged before using the stamp for the first time.
This takes about 14 hours.
Charging the batteries
Open the battery compartment
f
Check for correct polarity and insert the batteries.
f
Close the battery compartment
f
Charging the batteries
Put the jetStamp 790 in the charging station
f
Connect the Mini-USB socket
f
USB cable.
Connect mains unit to the mains.
f
Batteries are charged when the green charging control light
f
Charging condition is displayed by the symbol
f
Troubleshooting
The following message appears in the display
"EMPTY BATTERY - NO IMPRINT POSSIBLE".
The batteries have not been recognised by the system.
Press any key.

12
The display
Unallowed inputs may have been made.
Press the reset button

Fig. B

2
on the back of the stamp.
2
.
Fig.
A + D

7
of the charging station
is dark or lines appear.
3
.
4
with the locking tab
4
with the mains unit with the
6
is lit.
in the display
12
after inserting batteries
8
first.
12
after a few minutes.
GB
57