Reiner jetStamp 790 Bedienungsanleitung Seite 80

jetStamp 790/790 MP
4. Software Application 790 PCset easy
Customer-specific imprints P : 26 to P : 29, can be generated and transferred with the
790 PCset easy.
The online help of the 790 PCset easy software contains further information. To open
the online help, select the menu entry Help in the menu "Help" or push "F1".
4.1. Preparing jetStamp 790 for 790 PCset easy
Prepare jetStamp 790 for 790 PCset easy
For the device to be correctly recognised by the computer, the PCset graphic software
must be installed first (see page 63).
Connect Mini-USB socket
f
Push [MODE] until the display menu bar [SETUP] appears.
f
Push [SETUP].
f
"SETUP - MODULE SETTINGS" appears.
Push [NEXT].
f
"SETUP - MODULE UPDATE" appears.
Push [CALL].
f
"SM - UPDATE FIRMWARE ALL" appears.
Push [NEXT] twice.
f
"SM - UPDATE STAMP PICTURE" appears.
Push [START].
f
"SM - UPDATE STAMP PICTURE ACTIVE" appears.
4.2. Starting the Software
Double-click the 790 PCset easy symbol
f
The 790 PCset easy software is started.
4.3. Check connection
To check whether the PC is correctly connected to the jetStamp 790, click "Info" in the
menu "Help".
If the window "Info about 790 PCset easy" appears, the PC is connected to the
jetStamp 790 correctly.
If the window "Port settings" appears, observe notes in chapter "790 PCset easy
Troubleshooting" in the online help (see "Online Help", page 78).
78
fig.

7
to the PC via the USB cable.
.
A + E