Miele PDR 914 SOM Gebrauchs- Und Aufstellanweisung Seite 111

The machines are in a network and are connected to the Internet. All machines are con-
figured as slaves. Data is synchronised over the Internet.
Remote
Programmes are selected on an external terminal.
Factory default: Off
RemoteUpdate
The RemoteUpdate function is used for updating the software in your tumble dryer.
The RemoteUpdate function is deactivated as standard.
If you do not install a RemoteUpdate, you can continue to use your tumble dryer in the
usual way. However, Miele recommends installing RemoteUpdates.
The RemoteUpdate menu option is only displayed and can only be selected if you have
added your tumble dryer to your WiFi network.
Miele's RemoteUpdate function can only be used if the tumble dryer is connected to a WiFi
network and you have an account in the Miele Professional app. The tumble dryer must be
registered in the app.
See the Miele Professional app for terms and conditions of use.
Some software updates can only be carried out by Miele Service.
If a RemoteUpdate is available for your washing machine, it will be displayed automatically
when the Operator level is open.
You can choose to start the RemoteUpdate immediately or wait until later. If you select
"Start later", the prompt to run the RemoteUpdate will be displayed again the next time you
switch on your washing machine.
The RemoteUpdate can take a few minutes.
Please note the following information about the RemoteUpdate function:
- You will only receive a message when a RemoteUpdate is available.
- Once a RemoteUpdate has been installed, it cannot be undone.
- Do not switch off the tumble dryer during a RemoteUpdate. Otherwise, the RemoteUp-
date will be aborted and will not be installed.
SmartGrid
SmartGrid
The setting is only visible if a WiFi network has been set up and activated. This
function can be used for starting your Miele Professional machine automatically at a time
when your energy supplier's electricity tariffs are most economical.
SmartGrid
Activating
control to set SmartStart. The tumble dryer will then start within the timeframe specified
when it receives a signal from the energy supplier. If it has not received a signal from the
energy supplier by the latest start time set, the tumble dryer will start automatically.
Factory default: off
Timer
gives the sensor control a new function. Use the
en - Supervisor level
Timer
sensor
111