EN
OPENAIR
REQUIREMENTS TO INSTALL OPENAIR IN VEHICLES
WITH A ROOF HATCH
Caution: OPENAIR can only be installed in
vehicles with a hatch that are equipped with:
- 400 x 400 mm roof opening
- Roof 30 to 60 mm thick
Remove the hatch and the frame of the vehicle
4
where the OPENAIR unit will be installed.
OPENAIR UNIT INSTALLATION PROCESS
Lift the unit and attach the 35x35 EPDM seal
5
on the base of the unit, following the marked
area.
Caution: If the EPDM seal is installed in any
other location, the equipment will not work
properly and may cause the ingress of water.
EPDM seal
22
TU ESPACIO DE VIDA CONFORTABLE