Bergstrom OpenAir Montageanweisungen Seite 26

EN OPENAIR
Place fastening brackets on the studs on the
11
base of the unit and fasten the brackets with
(1) wide-rimmed washer and (1) self-locking
nut on each stud.
Caution: The assembly brackets should be
installed longitudinally in the vehicle's direction
of travel, such that the air outlet faces the front
and rear of the vehicle when the console is
installed.
Wide-rimmed washer
Tighten the self-locking nuts of the fastening
12
brackets by compressing the unit's outer
EPDM seal between 3 and 6 mm.
Important: The EPDM seal must be tight with
the base of the unit, as shown in the diagram,
in order to prevent any leakages of water
inside the cabin.
Tighten (4) top nuts of the brackets to
13
complete the fastening process. The brackets
should be fastened securely to the roof,
ensuring they remain flush and level. Any
other situations may lead to problems when
installing the interior console.
26
TU ESPACIO DE VIDA CONFORTABLE
Self-locking nut
Tighten the nut