Battery Charging - eta Master Pro II Bedienungsanleitung

Discontinuing/Continuing of the cleaning operation
The vacuum cleaner will continue cleaning, if disconnected cleaning operation will
be reactivated. Cleaning will also continue after successful completion of the charging
process, if the operation has been automatically discontinued due to low battery charge.
System reset
Remove the dust bin B (eventually the mop attachment C) and press the RESET button
A12 with a suitable tool.
– Please note that pressing the RESET button A12 will lose all the settings you
have set using the "ETA SMART" app.
– Voice notifications are factory set to Czech. You can only change to English in the app.
– UV cleaning can only be activated in the application.

5.2 BATTERY CHARGING

1. Check correct connection of the charging dock to mains power (lamp D1 must light on).
2. Place the device near the charging dock (approx. 0.5 m) and press A7 or the relevant
function in the app. If the battery is too low, place it directly onto the charging dock.
– Standard charging time is approx.4-5 hours. Operation time of the robot vacuum
cleaner with fully charged battery ranges 130 to 230 minutes, depending on set
functions, power and the area to be cleaned. The stated operating times are
based on ETA's internal testing and only apply to a new and fully charged battery.
Depending on the age and wear of the battery, the operating time decreases.
– The battery status information can be easily found in the "ETA SMART" app. This app
can also be used for sending the vacuum cleaner to the charging dock at any moment.
– If the device did not returned to the charging dock (e.g. due to obstacles) and the
battery level becomes critical, it will be switched off automatically.
5.3 CLEANING MODES AND VACUUM CLEANER FUNCTIONS
The vacuum cleaner has a total of 5 cleaning modes. Only automatic cleaning mode and
local cleaning are available by controlling without using the app.
Manual operation
You can operate the device manually using E2 direction buttons and clean only the areas
where cleaning is necessary.
Smart automatic cleaning
Press the A6 button on the control panel or the E1 button
on the remote control. During cleaning, the vacuum cleaner
moves gradually and systematically in the space according
to the programmed route. It divides the space into individual
segments. As soon as the vacuum cleaner cleans the entire
available space, it automatically searches for the charging
station. This is the most used method of cleaning.
WARNING
Remarks
EN - 47
EN