Vaccum Cleaner Use; Switching On The Vacuum Cleaner; Battery Charging - eta 512-Serie Bedienungsanleitung

EN

5. VACCUM CLEANER USE

Install the battery into remote control and virtual wall at right polarity.

5.1 SWITCHING ON THE VACUUM CLEANER

1. Set the main switch A6 to position "I".
2. An acoustic signal will sound and the light signal for buttons C1 and C2 will flash green.
If you use the vacuum cleaner together with the charging station and the scheduled
cleaning function, leave the main switch in the "I" position at all times (ON).

5.2 BATTERY CHARGING

1. Check that the charging station is properly connected to the mains. (light D1 must be on).
2. Place the vacuum cleaner near the charging station and press the F9 button on the
remote control. If the battery is too low, place directly and correctly the vacuum cleaner
on the charging station.
– The vacuum cleaner can be charged by directly connecting adapter E to power
connector A7. After charging, it is necessary to disconnect the power adapter from
the A7 connector of the vacuum cleaner.
– The standard charging time is approx. 6 hours. A fully charged battery will provide an
operating time of up to approximately 120 minutes.
– After cleaning, the vacuum cleaner will automatically search for the charging station.
– The "ETA SMART" application makes it easy to find out the battery status. The
application can also be sent back to the charging station at any time.
Set power
* Note: The stated operating times are based on ETA's internal testing
and only apply to a new and fully charged battery. Depending on the
age and wear of the battery, the operating time decreases.
5.3 START / STANDBY / SLEEP MODE
Start (Cleaning): the indicator light is green.
Standby mode (Pause): the indicator light flashes green.
Sleep mode: the indicator light is off.
Remarks
MIN
MAX
Note
Running Time *
Approx. 120 minutes
Approx. 65 minutes
EN - 52