Battery Charging - eta NAVAGGIO Bedienungsanleitung

GB
Sleeping mode
If the device is in stand-by mode (or after error message) and not any action has been
carried out during 5 minutes, it will be switched in sleeping mode. For activation, press any
button or use the app. During charging, the device cannot be activated.
Discontinuing/Continuing of the cleaning operation
The vacuum cleaner will continue cleaning, if disconnected cleaning operation will be re-
activated. Cleaning will also continue after successful completion of the charging process,
if the operation has been automatically discontinued due to low battery charge.

5.2 BATTERY CHARGING

1. Check correct connection of the charging dock to mains power (lamp D1 must light on).
2. Place the device near the charging dock (approx. 0.5 m) and press A7 or the relevant
function in the app. If the battery is too low, place it directly onto the charging dock.
– Standard charging time is approx. 3-4 hours. Operation time of the robot vacuum
cleaner with fully charged battery ranges 60 to 120 minutes, depending on set
functions, power and the area to be cleaned. The stated operating times are
based on ETA's internal testing and only apply to a new and fully charged battery.
Depending on the age and wear of the battery, the operating time decreases.
– The battery status information can be easily found in the "Navaggio" app. This app can
also be used for sending the vacuum cleaner to the charging dock at any moment.
– If the device did not returned to the charging dock (e.g. due to obstacles) and the
battery level becomes critical, it will be switched off automatically.
5.3 CLEANING MODES AND DEVICE FUNCTIONS
The vacuum cleaner has 6 cleaning modes. When the app is not used, only automatic
cleaning mode is available. The app allows extended function range, incl. mopping,
cleaning along the walls, local cleaning, zone cleaning and thorough cleaning (2x) +
adjustment of suction and mopping power, setting zones, cleaning process planning,
creation of cleaning maps (e.g. for various storeys of the house).
Smart automatic cleaning
Activation by pressing main switch button A6. During cleaning, the vacuum cleaner moves
gradually and systematically in the space according to the programmed route. It divides the
space into individual segments. As soon as the vacuum cleaner cleans the entire available
space, it automatically searches for the charging station. This is the most used method of
cleaning.
Return to the charging dock
In the automatic operation mode, the device can automatically return back to the charging
dock, when cleaning has been completed. You can also sent it to the charging dock by
pressing A7, or using return function in the app.
Return to the charging dock:
a) by pressing A7 button or using the app
b) cleaning has been completed
c) battery is low (after recharging, the cleaning process will continue)
Remarks
GB - 44