eta Master Pro II Bedienungsanleitung Seite 50

EN
– Dry cleaning is recommended to maintain HEPA filter parameters.
– If you choose to wash the HEPA filter with water, its filtering ability will be reduced.
– The maximum number of filter washes is 3x. Then it is necessary to buy a new one.
– It is recommended to change the HEPA filter at least twice a year.
– The filters are not intended for use in a dishwasher.
– Cleaning failure and possibly filters replacing can lead to malfunction of the vacuum
cleaner!
4. After performing the maintenance, reassemble the container including the filters and
insert it into the vacuum cleaner.
6.3 CLEANING THE MAIN BRUSH FIG. 4
1. Press both cover latches towards the brush and remove the placed cover A11.
Then remove the main brush A10 from the vacuum cleaner.
2. Clean the main brush with cleaning tool G (or other suitable). You can also use scissors
to remove tangled hair.
Wipe the main brush cover and the main brush area with a soft, dry cloth.
3. You can also slide out the A15 bearing from the A10a brush and remove any lint/hair
that got into this space.
4. In the opposite way, place all the removed elements back into the vacuum cleaner.
6.4 CLEANING THE SIDE BRUSHES
Remove the brushes by simply sliding them out, clean them and remove tangled hair from them).
6.5 CLEANING THE WHEELS
Clean the front, left and right wheels with the G tool.
Hair and other dirt can get tangled on the axles of the wheels.
6.6 CLEANING OF SENSORS A2/A17
After each cleaning is completed, clean the sensors with the G tool (or other suitable).
6.7 CLEANING THE MOPING ATTACHMENT
After each use, remove the attachment from the vacuum cleaner (see Fig. 3).
Mopping attachment C and rinse the C3 mops under running water.
6.8. CLEANING THE FRONT BUMPER A1
The front bumper contains obstacle sensors, so wipe it regularly with a damp cloth. Also
check if the front bumper can be moved slightly its entire circumference towards the robot
body and check that there is no obstacle stuck between the bumper and the robot.
6.9. CLEANING THE CHARGING STATION WITH SUCTION UNIT
1. Unfold cover D5 and remove dust bag D9. Dispose of it together with municipal waste.
Then insert a new empty dust bag into the unit.
NOTICE
WARNING
Check and clean the wheels regularly.
EN - 50