Trouble Shooting - eta Master Pro II Bedienungsanleitung

2. Pull out the protective filter D6. Rinse the filter under running water.
Then let it dry thoroughly and put it back in its place.
3. Also clean the D3 area carefully with a dry cloth.
Dirt and dust can accumulate around hole D4. Clean this area with a damp cloth or brush.
More extensive maintenance or maintenance requiring intervention in the inner parts
of the appliance must be carried out by a professional service! Failure to comply with
the instructions of the manufacturer will lead to expiration of the right to guarantee
repair!

7. TROUBLE SHOOTING

A large part of the various problems can be solved or prevented by proper operation
in accordance with the instructions in the manual. Above all, pay attention to proper
maintenance and visual inspection of the vacuum cleaner. Always restart the entire vacuum
cleaner to be sure and check the correct connection of the station to the electricity. sewing.
If some kind of error event occurs, the bot will notify you. Use the bot with an
application that will make the error more specific in other languages as well.
Problem
The vacuum cleaner
rotates in one place.
The vacuum cleaner is
still backing up.
The vacuum cleaner
constantly hits obstacles.
The vacuum cleaner
cleans for a very short
time.
The suction power of
the vacuum cleaner
decreases.
Mapping function failure.
Programmed cleaning
map is incorrect/chaotic.
Device cannot be
switched on
Note
Cause
Left / right wheel is stuck.
Sensors preventing from
falling down the stairs are
dirty/damaged.
The front bumper is
jammed due to dirt.
The storage battery is not
charged enough or is at
the end of its life.
The dustbin is full or the
filters are dirty.
Obstruction of the laser
module.
Battery discharged.
Extreme ambient
temperature
EN - 51
Remedy
Check and clean the wheels
Clean the sensors. If the
problem persists please contact
authorised service centre.
Check and clean the front
bumper.
Fully charge the vacuum
cleaner. If the problem persists,
replace the storage battery with
a new one.
Check and clean the dustbin
and filters.
Check the module, and remove
obstructions, if any. The laser
mechanism below the module
must freely rotate.
Recharge the battery.
Ambient temperature must not
be lower than 0 °C and higher
than 40 °C.
EN