cecotec Cumbia POWER ESPRESSO 20 BARISTA MINI Bedienungsanleitung Seite 50

ENGLISH
it is very important to know all the factors that affect this process. The following section
explains how to obtain a perfect coffee.
- In case of very high pressures this may be due to the fact that the ground coffee used is
very fine and/or that the pressure exerted on the coffee in the filter is very high.
- In case of very low pressures this may be due to the fact that the ground coffee used is
too coarse and/or the pressure is too low.
Espresso coffee
1. Open the lid, remove the water tank and pour adequate water into the tank. Do not exceed
MAX capacity.
2. Re-install the water tank and close the lid.
3. Plug in the power plug. All buttons light up completely and then turn off. Touch the power
switch, the single and double coffee indicators flash, the steam switch indicator lights up
steady and the machine starts to heat up. After about 1 minute, all indicators are steady,
indicating that preheating is complete.
4. Take out the filter holder, pour the ground coffee (9 grams for single and 16 for double)
as preferred into the corresponding coffee filter with the spoon, then press the ground
coffee firmly with the spoon/presser, wipe off the excess ground coffee that overflows
the edge of the filter holder, to avoid damaging the sealing ring of the group head.
Note: if too much ground coffee is left on the edge of the filter, it is easy to cause a poor seal
and water leakage.
5. Position and rotate the filter holder assembly counterclockwise from position
position and tighten it correctly.
6. Place the cup(s) under the coffee spout.
7. Touch the single or double coffee switch and the machine will start pumping water and
coffee will come out of the portafilter hole.
8. The machine stops operating at the end of the preset time and the indicators remain
fixed. Remove the cup of coffee.
Warning
- Do not leave the coffee machine unattended during the brewing process, as it sometimes
requires manual operation.
- Once the coffee has been brewed, remove the high-pressure filter holder assembly by
turning it clockwise, clean the coffee grounds from the filter in good time and rinse it with
hot water. Touch the button for one or two cups of coffee, rinse the spout with water,
install the clean high-pressure filter holder assembly in the spout and wait for the next
use.
Warning: do not touch the hot surfaces of the machine with your hands to avoid burns,
especially the pouring spout and the steam nozzle when using the machine.
50
to