Husqvarna 135R Bedienungsanweisung Seite 12

Introduction................................................................... 12
Safety............................................................................13
Assembly...................................................................... 19
Operation...................................................................... 20
Maintenance................................................................. 23
Troubleshooting............................................................ 27
Product description
This product is a brushcutter with a combustion engine.
Work is constantly in progress to increase your safety
and efficiency during operation. Speak to your servicing
dealer for more information.
Intended use
Use the product with a saw blade, a grass blade or a
trimmer head to cut different types of vegetation. Do
Product overview
(Fig. 1)
1. Trimmer head
2. Grease filler cap, bevel gear
3. Bevel gear
4. Cutting attachment guard
5. Shaft
6. Handlebar
7. Throttle trigger
8. Stop switch
9. Throttle trigger lockout
10. Suspension ring
11. Cylinder cover
12. Starter rope handle
13. Fuel tank
14. Choke control
15. Primer bulb
16. Air filter cover
17. Handle adjustment
18. Locknut
19. Support flange
20. Support cup
21. Drive disc
22. Blade
23. Operator's manual
24. Transport guard
25. Locking pin
26. Harness
27. Spark plug cap and spark plug
28. Start throttle button
12
Contents
Transportation, storage and disposal........................... 27
Technical data.............................................................. 28
Accessories.................................................................. 29
Declaration of Conformity............................................. 31
Appendix ....................................................................616
Introduction
not use the product for other tasks than grass trimming,
grass clearing and forestry clearing. Use a saw blade to
cut fibrous types of wood. Use a grass blade or trimmer
head to cut grass.
Note:
National or local regulations can regulate the
use. Comply to given regulations.
Only use the product with accessories that are approved
by the manufacturer. Refer to
29. Throttle wire adjustment
30. Combination wrench
31. Guard extension
32. Shaft coupling
Symbols on the product
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 7)
Accessories on page 29 .
WARNING! This product is dangerous.
Injury or death can occur to the operator
or bystanders if the product is not used
carefully and correctly. To prevent injury
to the operator or bystanders, read
and obey all safety instructions in the
operator's manual.
Read the operator's manual carefully
and make sure that you understand the
instructions before use.
Stop.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection and approved eye
protection.
Maximum speed of the output shaft.
The product agrees with the applicable
EC directives.
975 - 010 - 11.09.2023