Parkside PWD 12 B1 Originalbetriebsanleitung Seite 26

GB MT
3. Insert the castors (7) into the mounts on
the bottom of the dirt container.
4. Mount the motor head (1).
Attaching and removing the
suction hose
Suction hose assembly (Fig. C)
1. Insert the thick end of the suction hose
(13) with the locking lever in the recess
into a connector:
• Vacuuming: Suction connector (5)
on the dirt container
• Blowing: Blowing connector (9) on
the motor head
You will hear the locking lever click into
place.
Attaching the suction hose (Fig. C)
1. Press and hold the locking lever on the
suction hose (13).
2. Pull the suction hose out of the connect-
or.
Attaching and removing the
suction pipe
Procedure (Fig. B)
• You can easily plug together or pull
apart the individual parts of the suction
pipe (12).
• You can use as many of the individual
parts of the suction pipe to vacuum or
blow.
Attaching and removing the
filter and filter bag
Overview
The device has the following filters and
bags:
• Textile filter (16)
• Dry vacuuming
• Use an additional paper filter bag
so that the textile filter does not clog
up so quickly.
26
• Foam filter (15)
• Wet vacuuming
• Paper filter bag (17)
• Dry vacuuming
• Fine dust filter bag
• Vacuuming fine dust
• available as accessories
Removing the textile filter (Fig. D)
1. Remove the motor head (1).
Place the motor head (1) with the top
facing downward.
2. Remove the textile filer (16).
3. see Installing the foam filter (Fig. E);
Blowing, p. 28
Installing the textile filter (Fig. D)
1. Remove the motor head (1).
Place the motor head (1) with the top
facing downward.
2. Remove the foam filter (15).
3. Pull the textile filter (16) completely
over the filter basket (21).
4. Mount the motor head.
5. Dry vacuuming, p. 27; Vacuuming
fine dust, p. 28
Installing the filter bag (Fig. D)
These instructions apply for the paper fil-
ter bag (17) and the fine dust filter bag
(available as accessories).
1. Remove the motor head (1).
Place the motor head (1) with the top
facing downward.
2. Inside the dirt container (6), pull the fil-
ter bag over the suction connector (5).
The sealing ring 22 on the filter bag
opening must fully surround the con-
nector on the suction connector (23).
3. Mount the motor head.
Removing the filter bag (Fig. D)
1. Remove the motor head (1).
Place the motor head (1) with the top
facing downward.