Zulassung Für Kanada - Siemens SINAUT ST7 Handbuch

If your telephone equipment causes harm to the telephone network, the Telephone
Company may discontinue your service temporarily. If possible, they will notify you in
advance. But if advance notice is not practical, you will be notified as soon as possible. You
will be informed of your right to file a complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the proper functioning of your equipment. If they do, you will be
notified in advance to give you an opportunity to maintain uninterrupted telephone service.
If you experience trouble with this telephone equipment, please contact
SIEMENS Energy & Automation, Inc.
Factory Service Center
3000 Bill Garland Road
Johnson City, Tennessee 37605
Tel: (423) 461-3000
for information on obtaining service or repairs. The telephone company may ask that you
disconnect this equipment from the network until the problem has been corrected or until you
are sure that the equipment is not malfunctioning.
This equipment may not be used on coin service provided by the telephone company.
Connection to party lines is subject to state tariffs.
Zulassung für Kanada
INDUSTRY CANADA (IC) NOTICE
The Industry Canada (IC) label identifies certifies equipment. This certification means that
the equipment meets telecommunications network protective, operational and safety
requirements as prescribed in the appropriate Terminal Equipment Technical Requirements
document(s). The department does not guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to
the facilities of the local telecommunications company. The equipment must also be installed
using an acceptable method of connection. The customer should be aware that compliance
with the above conditions may not prevent degradation of service in some situations,
Repairs to certified equipment should be coordinated by a representative designated by the
supplier. Any repairs or alterations made by a user to this equipment, or equipment
malfunctions, may give telephone communications company cause to request the user to
disconnect the equipment.
Users should ensure for their own protection, that the electrical ground connections of the
power utility, telephone lines an international metallic water pipe system, if present, are
connected together. This precaution may be particularly important in rural areas.
Caution
Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority or electrician, as appropriate.
Stationsleitsystem
Systemhandbuch, 05/2007, C79000-G8900-C178-06
VORSICHT
Einführung in das SINAUT ST7-System
2.12 Normen und Zulassungen von SINAUT ST7-Produkten
103