Connecting The Charger; Preliminary Settings: Language, Light Intensity And Sound Volume - Compex Mi-Sport Gebrauchsanleitung

It is important to place the electrodes
correctly to the cable connectors; in order
to do so, press the connector to the electrode
until you hear a click.
Connecting the motor point pen
Use the motor point pen strictly for
locating a motor point, as per the
instructions described in this ma-
nual. Before using the motor point pen,
clean and disinfect the tip of the pen.
he Compex is supplied with a motor
T
point pen that allows you to locate
exactly the motor point of the muscular
group(s) to be stimulated. The follo-
wing diagram indicates how to connect
this accessory.
1c
1c You must connect the positive (red) connection
to the tip of the motor point pen. The other connec-
tion (black) must be connected to the negative
electrode, placed according to the picture for the
stimulated muscle.
Note: Concerning the actual use of the
pen, refer to applications manual : " Test
category", " Locating a motor point ".

Connecting the charger

he Compex has considerable opera-
T
ting autonomy, as it uses rechargeable
batteries. To recharge them, use the
charger supplied with your device and
connect it to the base of the device,
then plug the charger in a socket.
o recharge the Compex, first discon-
T
nect the electrode cables from the
device.
efore using your stimulator for the
B
first time, it is always strongly recom-
108
mended that you completely charge
the battery to improve its autonomy
and extend its working life.
3. Preliminary settings:
language, light intensity
and sound volume
efore using the unit for the first time,
B
you should select the working language
of the device which is displayed on
the options screen. Proceed as per
the instructions described below.
fterwards, for the greatest comfort,
A
Compex offers you a number of setting
options (operating language selection,
display contrast setting, adjusting
backlighting and sound volume
setting).
o do this, display the options screen
T
by pressing the "On/Off" switch on
the left of the Compex and hold it
down for a few seconds.
2e
2a
Fig. 2
2a To select the language of your choice, press
the "+"/"–" key of channel 1.
2b To set the contrast of the display, press the
"+"/"–" key of channel 2.
2c To set the sound volume, press the "+"/"–" of
channel 3.
2d To adjust backlighting, press the "+"/"–" key
on channel 4 (on: backlighting is permanently
activated; off: it is not activated; auto: it is
activated every time a key is pressed)
2e To confirm the parameters selected, press
the "On/Off" switch. Your stimulator saves your
options. It is now ready for use with the settings
you selected.
2b 2c
2d