Siemens SIPROTEC 5 Handbuch Seite 193
Communication protocols
Vorschau ausblenden
Andere Handbücher für SIPROTEC 5:
- Handbuch (1284 Seiten) ,
- Gerätehandbuch (128 Seiten) ,
- Produktinformation (16 Seiten)
Werbung
Cyclic Data Transmission
(Station-specific parameter, mark X if function is only used in the standard direction, R if only used in the
reverse direction, and B if used in both directions)
Cyclic data transmission
Read Procedure
(Station-specific parameter, mark X if function is only used in the standard direction, R if only used in the
reverse direction, and B if used in both directions)
Read procedure
Spontaneous Transmission
(Station-specific parameter, mark X if function is only used in the standard direction, R if only used in the
reverse direction, and B if used in both directions)
Spontaneous transmission
Double Transmission of Information Objects With Cause of Transmission Spontaneous
(Station-specific parameter, mark each information type X where both a Type ID without time and correspon-
ding Type ID with time are issued in response to a single spontaneous change of a monitored object)
The following type identifications may be transmitted in succession caused by a single status change of an
information object. The particular information object addresses for which double transmission is enabled are
defined in a project-specific list.
Single-point information M_SP_NA_1, M_SP_TA_1, M_SP_TB_1 and M_PS_NA_1
Double-point information M_DP_NA_1, M_DP_TA_1 and M_DP_TB_1
Step position information M_ST_NA_1, M_ST_TA_1 and M_ST_TB_1
Bitstring of 32 bit M_BO_NA_1, M_BO_TA_1 and M_BO_TB_1 (if defined for a specific project)
Measured value, normalized value M_ME_NA_1, M_ME_TA_1, M_ME_ND_1 and M_ME_TD_1
Measured value, scaled value M_ME_NB_1, M_ME_TB_1 and M_ME_TE_1
Measured value, short floating point number M_ME_NC_1, M_ME_TC_1 and M_ME_TF_1
Station Interrogation
(Station-specific parameter, mark X if function is only used in the standard direction, R if only used in the
reverse direction, and B if used in both directions)
Global:
Global
Group:
(Information Object Addresses assigned to each group must be shown in a separate table)
Group 1
Group 2
Group 3
Group 4
Group 5
Group 6
SIPROTEC 5, Communication Protocols, Handbuch
C53000-L1800-C055-H, Ausgabe 07.2023
Group 7
Group 8
Group 9
Group 10
Group 11
Group 12
IEC 60870-5-104
4.3 Interoperabilität
Group 13
Group 14
Group 15
Group 16
193
Werbung
