Werbung
Troubleshooting
Perform the following actions.
If the problems still cannot be solved or all self‑cleaning
recharger's lamps blink, contact the store where you
purchased the unit or a service centre authorized by
Panasonic for repair.
►Self-cleaning recharger
Problem
The blade has not been
thoroughly washed.
ES-LV9N_EU.indb
23
Action
If the shaver is not cleaned for
more than 2 weeks, first clean
with the cleaning brush to
remove beard trimmings.
(See page 19.)
Do not add detergent and water
except when replacing the
cleaning liquid.
Doing so may deteriorate the
cleaning function.
(See page 21.)
After cleaning, oil‑like droplets
may remain on the outside of
the foil frame. This is the
lubricating component of the
cleaning liquid and does not
indicate a problem. You may
wipe it off with a soft cloth.
Problem
The blades may not dry quickly
due to temperature conditions.
The blades are not dry
Run the "Dry/Charge" mode
or are sticky.
again or wipe with a soft cloth
before shaving.
Do not insert any foreign
objects into the recharger.
The blades crack or
Replace the system outer foil
deform during cleaning.
and/or inner blades.
(See page 19.)
If you mix soapy water or hand
soap with the detergent or use
another detergent, the cleaning
liquid will foam. Use the self‑
The cleaning liquid has
cleaning recharger after
foamed.
thoroughly washing and drying
the shaver.
Replace the cleaning liquid.
(See page 20.)
Remove any waste, etc. that
has accumulated in the drain at
the bottom of the cleaning tray.
(See page 21.)
Cleaning liquid has
If you use the self‑cleaning
accumulated in the
recharger when the shaver is
cleaning tray.
wet or when soap or shaving
gel is on the shaver, cleaning
liquid may accumulate in the
cleaning tray.
Action
23
2015/12/11
13:05:58
Werbung
