Werbung
► Drying the shaver without the self-cleaning recharger
Allow the shaver to dry in the shade,
avoid direct sunlight and then apply oil.
Notes
• Be careful not to hit the main body on the sink or any other
object while draining the water. Failure to do so may cause
malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, or cracking or discoloration
of the parts.
Wipe with diluted soapy water.
• Do not use any kitchen or bathroom detergents other than
hand soap.
Doing so may cause malfunction.
• Do not use the self‑cleaning recharger while droplets or soap
remain on the shaver.
Doing so may change the concentration level or composition
of the cleaning liquid in the cleaning liquid unit, which may
degrade cleaning, sterilization, lubrication and drying
performance. This may also cause cleaning liquid to spill
from the self‑cleaning recharger.
ES-LV9N_EU.indb
19
Cleaning with the brush
Remove the outer foil section and the inner blades.
(See page 20.)
►Cleaning with the long brush
Clean the outer foil section
[A9], system outer foil [A2],
the shaver body [A] and the
trimmer [A<] using the long
brush.
►Cleaning with the short brush
• Clean the inner blades [A;] using
the short brush by moving it in
direction as illustrated.
• Do not move the short brush
perpendicularly against the blades
as it will damage the inner blades
and affect their sharpness.
Replacing the system outer foil and
the inner blades
appears on the lamp display once a year. (Based on one
3‑minute shave use per day)
We recommend checking the system outer foil and the inner
blades when it appears.
Press the power switch for more than 30 seconds to turn off
Even if
is not turned off right after the replacement, it will
automatically turn off within approximately 7 uses.
system outer foil
once every year
inner blades
once every two years
.
19
2015/12/11
13:05:57
Werbung
