Werbung
Notes
• The cleaning liquid will decrease every time it is used, but do
not add detergent and water except when replacing the
cleaning liquid.
Doing so may deteriorate the cleaning function.
• Do not wash the self‑cleaning recharger unit with water.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, or cracking or discoloration
of the parts.
Wipe with diluted soapy water.
• Some cleaning liquid components and skin oil may separate
and adhere to the cleaning liquid unit and cleaning liquid
filter. This does not indicate a problem.
► When the water does not drain from the cleaning tray
• Do not tilt the self‑cleaning recharger to pour out water.
Doing so may cause the cleaning liquid in the cleaning liquid
unit to spill or cause the self‑cleaning recharger to
malfunction.
• Beard trimmings may clog the drain at the
bottom of the cleaning tray.
In this case, you cannot clean or dry the
shaver.
1. Be sure to remove the AC adaptor from the
self‑cleaning recharger.
2. Place the self‑cleaning recharger on a flat
surface, and push the beard trimmings down
through the drain (b) with a toothpick etc.
ES-LV9N_EU.indb
21
When the LOW/STATUS lamp glows
It indicates that the cleaning liquid is due for replacement
when the LOW lamp or STATUS lamp glows for approximately
5 seconds when the SELECT button is pressed.
Lamp on the
self-cleaning recharger
The LOW lamp glows.
The STATUS lamp glows.
Content of notification
Replacement of the cleaning
liquid is required in
approximately 7 days.
Prepare the detergent.
Replace the cleaning liquid.
(Modes other than the "AUTO"
mode can be used even if it is
not replaced.)
If you think the replacement
should not be due yet...
• Is the cleaning liquid unit
correctly attached?
• Is the self‑cleaning recharger
placed in a level surface?
• Is the self‑cleaning recharger
used outside the range of the
recommended usage
temperature?
(Only "Charge" mode can be
used.)
21
2015/12/11
13:05:58
Werbung
