Nilfisk SC370 43B Wartungshandbuch Seite 30

Service Manual- SC370
Battery
Installation
1. Empty the recovery tank with drain hose.
2. Remove the recovery tank assembly (A, Figure 14).
3. The machine is equipped with battery cables suitable for installing 2X12V batteries. Carefully put the batteries
into the compartment and install them as shown in the diagram near the batteries.
4. Route and connect the battery cables (connect the battery cable to battery negative terminal last and disconnect
it first), then carefully tighten the nut on each battery terminal.
5. Place the protection cap on each terminal, then connect the battery connector (B, Figure 14).
6. Carefully put back the recovery tank assembly (A, Figure 14).
Removal
Disassemble components in reverse order of assembly.
Specifications
Description
Battery Voltage
Battery Charger Voltage
Figure 14
Unit
V
V
24 Electrical System 29
Value
24
24