Nilfisk SC370 43B Wartungshandbuch Seite 27

Service Manual- SC370
Maintenance and Adjustment
Machine Battery Type Setting
According to the battery type (WET/GEL/AGM/DIS), set the machine as follows:
1. When one-button start (S3) is switched off, press flow increase switch and flow decrease switch (S5 and S6) at the
same time. 0.5 seconds later, LED1, LED2 and LED3 will all light up and the machine enters the battery type setting
mode.
2. Then press flow increase switch or flow decrease switch to select battery type among "WET", "GEL/AGM" and "DIS-
EV". If "WET" battery type is selected, LED1 (red) is on. For "DIS-EV", LED2 (yellow) is on
LED3 (green) is on.
3. Press one-button start to exit battery type setting mode, and turn off the machine to update the battery type. When
it's turned on again, the machine battery type is updated accordingly, and the corresponding LED will flash twice.
Charger Battery Type Setting
1.
Remove all the screws (A,B,C, Figure 6)
2.
Open the charger and find SW1 (D, Figure 6)
3.
Set DP1 and DP2 according to the table in Figure 6.
4.
Install the screws (A,B,C, Figure 6) after the setting.
Figure 5
.
.
24 Electrical System 26
And for "GEL/AGM",
.
Figure 6