Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Vacuum Sweeper
AKS 80|VM 108
CHAPTER 15 - DECOMMISSIONING
Use up any remaining petrol in the tank by leaving the machine running;
Clean the machine in general (with the motor off and cold);
Clean the dust filters and the hopper; if necessary, clean the hopper, observing the instructions
provided in paragraph "Debris hopper" in Chapter 13.
CHAPTER 16 - DISMANTLING AND DEMOLITION
________________________________________________________________________________________
DISMANTLING OR DEMOLITION MUST BE CARRIED OUT BY THE CUSTOMER, IN FULL
OBSERVANCE OF STANDARDS IN FORCE, BY HANDING THE ENTIRE MACHINE OR ITS PARTS OVER TO
COMPANIES SPECIALISED IN THESE SERVICES.
________________________________________________________________________________________
CHAPTER 17 - EMERGENCY SITUATIONS
IN ANY EMERGENCY SITUATION YOU MAY FIND YOURSELF IN, FOR EXAMPLE: IF YOU HAVE INADVERTENTLY
DRIVEN THE MACHINE OVER POWER CABLES SET UP ALONG THE FLOOR, WHICH HAVE TANGLED AROUND THE
CENTRAL OR SIDE BROOM, OR IF YOU CAN HEAR AN UNUSUAL NOISE FROM INSIDE THE MACHINE OR MOTOR,
OR IF INCANDESCENT MATERIALS OR FLAMMABLE LIQUIDS, CHEMICAL MATERIALS IN GENERAL, POISONS, ETC.
HAVE BEEN COLLECTED.
YOU MUST:
Press the red button located to the left of the operator Detail 1 Fig. 12/A; as they are no longer powered, all of
the motors will immediately stop.
CHAPTER 18 - TROUBLESHOOTING
There are essentially two problems that can happen with sweepers, i.e.: the machine produces dust during
operation, or it leaves debris on the floor; there can be many causes, but with careful use and good routine
maintenance these problems will not arise, therefore:
FAULTS
The machine produces dust.
The debris comes out of the motor
compartment
The machine leaves debris on the
floor.
The internal combustion motor
does not start up or it tends to
stop on bends
CAUSES
Clogged filter.
Damaged filter.
Filter assembled incorrectly.
Damaged side washers.
The central broom is not adjusted
accordingly, or it is worn.
You have collected wires, cords etc...
Damaged side washers.
The hopper is full.
Make sure the electric start is
working correctly and/or the
button
Check the motor oil level, which
must always be at the maximum
level
Make sure there is fuel
28
REMEDIES
Clean it by 'shaking' it with relative
tools and remove it and clean it
thoroughly, as needed.
Replace it.
Assemble it with its washer and make
sure it is installed correctly and firmly
with even force.
Adjust them or replace them.
Adjust the central broom and check its
'track'.
Remove them.
Change it/them.
Empty it out.
Change it/them
Top up oil
Fill up with fuel
Werbung
