Herunterladen Diese Seite drucken

Columbus AKS 80 VM 108 Original Bedienungsanleitung Seite 27

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Vacuum Sweeper
AKS 80|VM 108
1 -
Disassemble the left side (on the driver's side) Part. 1 (LT) Fig. 17, by simply lifting it out of the
bayonet joints.
2 -
Unscrew the two clamping screws from the semi-arm Detail 4 Fig. 17;
3 -
Unscrew the three screws that surround the side casing Detail 5 Fig. 17.
4 -
Slide off the side broom Detail 6 Fig. 17 and replace it, being careful of the direction of the bristles,
which must be set up as in Figure 17.
6 -
to complete assembly, repeat the operations in reverse order.
7 -
Adjust the height of the new broom (see paragraph "Central Broom Adjustment").
REPLACING THE SIDE BROOM:
This operation must be carried out with the motor off.
1-
Unscrew the ring nut Detail 1 Fig. 18 located centrally and under the side broom, which will
automatically descend.
2-
Change the worn broom with the new one, tightening the ring nut firmly.
SPECIFIC MAINTENANCE FOR INTERNAL COMBUSTION ENGINES
________________________________________________________________________________________
TO CHECK OR CHANGE MOTOR OIL IT IS NECESSARY TO WEAR GLOVES, POSSIBLY
COTTON-LINED NITRILE RUBBER; DO NOT DISPOSE OF OIL AS HOUSEHOLD WASTE
AS IT IS HIGHLY POLLUTING; DISPOSE OF EXHAUSTED OIL IN ACCORDANCE OF
LEGISLATION IN FORCE.
________________________________________________________________________________________
Read the attached instructions booklet for the motor carefully, and note:
IMPORTANT: AKS 80 VDM motors are equipped with an OIL-ALERT system, which does not allow
the motor to switch on when the oil is low or empty.
1)
Check the oil level every 20 hours of operation.
2)
First oil change after 10 hours of operation, the sump contains approximately hg. 6 of oil; the
recommended oil for temperate climates is 10W-30 multi-grade for motors that run on petrol. When
operating the machine in non-temperate climate zones, identify the suitable type of oil from the motor
booklet. Use the designated oil discharge pipe for oil changes.
3)
Change oil every 40/50 hours of operation thereafter.
4)
Clean the motor air cartridge every 25 hours of operation, or sooner if necessary, and replace when
necessary (see motor booklet).
CHAPTER 14 - UNSCHEDULED MAINTENANCE
________________________________________________________________________________________
UNSCHEDULED MAINTENANCE ARE ALL OF THOSE OPERATIONS THAT ARE NOT BEEN
MENTION
ED HEREIN; ACCORDINGLY, THEY MUST BE CARRIED OUT BY SPECIALISED ASSISTANCE
STAFF, A
PPOINTED FOR THIS PURPOSE (SEE BOOKLET COVER).
________________________________________________________________________________________
27

Werbung

loading