Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Vacuum Sweeper
AKS 80|VM 108
CHAPTER 10 - CHECKS BEFORE IGNITION
1 -
Read the instructions booklet, attached herein, for the motor carefully, and always:
2 -
Check the motor oil level, and top up if low.
3 -
Fill up with petrol.
4 -
IMPORTANT : the petrol container must be suitable for this purpose and clean. This will
ensure that the petrol filter and carburetor are always clean. Keep out of the reach of
children.
CHAPTER 11 – IGNITION AND STOP
________________________________________________________________________________________
BEFORE PROCEEDING IT IS NECESSARY TO HAVE READ ALL OF THE PREVIOUS
CHAPTERS.
______________________________________________________________________________
IMPORTANT: To start up the machine you must be seated in the driver's seat. If the operator is not
seated, or if he/she stands up once the machine has been switched on, it will switch off.
IGNITION:
Press and hold down the electric start button Detail 4 Fig. 11.
Place the accelerator lever in the max (hare) position Detail 7
Turn the ignition key counter clockwise, past the first notch Detail 6.
Once the motor is running, let go of the ignition key and keep holding the electric start button
down for a few seconds. At the same time adjust the rpm from the accelerator lever. It is
advisable to let the motor warm up at minimum rpm for a few minutes before starting work.
Once the motor is warmed up, lower the central broom lever to pos. 1 as illustrated in Fig.10
FORWARD DRIVE:
Press the drive pedal with your right foot Detail 3 Fig. 7 in the forward drive direction (see
arrow on pedal). Press the pedal gradually, never using abrupt movements, for a smooth start-
up and to speed up gradually.
REVERSE:
Press the drive pedal with your right foot Detail 3 Fig. 7 in the reverse drive direction (see
arrow on pedal). Press the pedal gradually, never using abrupt movements, for a smooth start-
up and to speed up gradually. For safety reasons, the reverse drive speed is very slow.
NEUTRAL:
Take your foot off the drive lever
STOP:
Release the drive pedal Detail 3 Fig. 7; you will notice that the machine tends to stop within a short
distance, if you wish to stop press the brake pedal abruptly Detail 1 Fig. 7.
CHAPTER 12 - CORRECT USE AND TIPS
IMPORTANT: Before starting operation, check for cords, plastic or metal wires or long rags, sticks,
power cords etc on the surface; these are dangerous and could damage the dust washers and brooms.
It is therefore necessary to remove them before operating the machine.
24
Werbung
