Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Vacuum Sweeper
AKS 80|VM 108
CHAPTER 3 - PREPARATION (UNPACKING)
Once the external packaging has been removed, take the machine off of its pallet; this operation can be carried
out in two ways:
1) Use a three-pronged hook with a suitable capacity for the weight of the machine (provided on the CE plate).
Lift the motor hood until it is resting on the steering wheel, all the way open. Screw the eye-bolt all the way
into the threaded hole on the platform by first of all taking the casing off of the motor (Part. 7 Fig. 4).
Hook all of the prongs onto the lifting hooks (all three) marked as A/B/C in Fig. 1 and using a forklift or
bridge crane (with a suitable capacity for the machine), lift it off of the pallet and very slowly place it on the
ground.
THE MACHINE CAN ONLY BE LIFTED WHEN ALL THREE STRAPS ARE HOOKED ONTO THE RESPECTIVE
2) Retrieve the relative ramps for the pallet and put them in position, screwing them on with the supplied
screws, as shown in Fig. 2; remove the pieces of wood that surround the wheels and disengage the parking
brake Fig. 3, pressing it to release the brake lever. It is now possible to push the machine onto the slide
(this must be carried out when no one is stationed in front of the machine and on a spacious flat surface)
At the end of the unpacking operation, take off and store the hooks (eye bolts), and install the right and left side
brooms, as shown in paragraph "side broom replacement" in chapter 13.
IMPORTANT: All waste material from the unpacking operations must be disposed of by the user, in
accordance with the specific standards for disposal currently in force.
MAKE SURE THAT THE GUARDS ARE PERFECTLY INTACT AND SECURELY INSTALLED;
IN CASE OF FAULTS OR MISSING PARTS DO NOT PROCEED WITH COMMISSIONING
AND PROMPTLY ASK FOR SPARE PARTS FROM YOUR DEALER OR THE PARENT
COMPANY.
CHAPTER 4 - ALLOWED AMBIENT CONDITIONS
Consult the attached motor instructions booklet, and nevertheless:
Minimum operating temperature:
Maximum operating temperature:
IMPORTANT: Do not use and do not leave at temperatures above + 40 ° C (+ 104 ° F ).
CHAPTER 5 - ALLOWED AND FORBIDDEN OPERATING CONDITIONS
ALLOWED OPERATING CONDITIONS
Sweepers are designed to clean processing residues, dust, debris in general, all flat, hard surfaces that are not
overly rough such as: cement, tarmac, stoneware, ceramic, wood, sheet metal, marble, rubber mats or made with
plastic materials in general, coarse or smooth, synthetic or flat fibre carpeting, in closed or outdoor settings.
FORBIDDEN OPERATING CONDITIONS
Sweepers with a standard control unit cannot be used on gradients greater than 18%.
They cannot be used in settings where there are explosive or flammable materials.
LIFTING HOOKS.
- 20 °C
+ 38 °C
19
( - 4 °F )
( + 100.4 °F )
Werbung
