Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Vacuum Sweeper
AKS 80|VM 108
Press this pedal Part. 1 Fig. 7 to make the machine slow down and stop (until it is released).
PARKING BRAKE:
If you wish to leave the machine with the Park brake on (Parking), it is necessary to do the following: using your
LT foot press the brake pedal all the way down and then slightly lift your foot to lock the brake. To release the
parking brake, simply press the pedal again Detail 1 Fig. 8.
FORWARD AND REVERSE DRIVE:
Detail 3 Fig. 7. This pedal is used to place a running machine in forward or reverse drive. Press the
pedal gradually, never using abrupt movements, for a smooth start-up and to speed up gradually. For
safety reasons, the reverse drive speed is very slow. When the machine is in neutral, it can be pushed
forwards or in reverse.
LEVER TO ENGAGE SIDE BROOM:
The lever to engage the side broom, Detail 1 Fig. 9, makes it possible to lower the broom from the driver's seat;
please remember that the side broom must only be used to clean edges, profiles and corners. To lower and
operate the side broom, lift the lever Detail 1 Fig. 9; to disengage it, place the lever back in its initial lowered
position.
________________________________________________________________________________________
AS IT IS ROTATING, NEVER TOUCH THE SIDE BROOM WITH YOUR HANDS AND DO
NOT COLLECT STRINGY MATERIALS.
________________________________________________________________________________________
LEVER TO ENGAGE CENTRAL BROOM
This lever, Fig. 10, this is used to lift and lower the central broom off and onto the floor.
In Fig.10-1 the broom is lowered in the working position, in pos. 2 the broom is raised in its resting
position. The central broom nevertheless turns in both positions.
EQUIPMENT ON THE AKS 80 VDM 108 CONTROL PANEL - FIG. 11
8) FILTER SHAKE BUTTON
9) HORN BUTTON
10) WORK LIGHT SWITCH
11) ELECTRIC START BUTTON
12) HOUR METER
13) IGNITION KEY
14) ACCELERATOR
FILTER SHAKE BUTTON:
Detail 1 This is used to make the suction filters vibrate electrically (to clean them), by means of an electric
vibrator; it must be pressed at least 5/6 times for 4/5 seconds every time (this procedure must be carried out
before operating the machine, before emptying out the debris hopper and the motor must be off).
HORN BUTTON:
Detail 2 Press this button to sound the horn (Klaxon).
WORK LIGHT SWITCH:
Detail 3 This is used to turn the work lights on.
ELECTRIC START BUTTON:
22
Werbung
