Wilfa INNOBOT RVC-D4000SL Anleitung Seite 24

Please clean the surfaces of
EN the front part of the robot
and the bottom sensor to
remove any dust.
The cliff sensor fails. Please
clean and move it to a new
position to start.
Laser radar is blocked. Check
the laser radar
The dust box has not been
cleaned for a long time.
Please clean it immediately.
Virtual wall or forbidden area
detected. Please move the
robot out of this area.
Appliance is trapped.
Remove any obstacle around
the device and try again.
Please put the appliance
back onto the base.
A new environment is
detected. Please re-start
cleaning task.
INSTRUCTION MANUAL · ROBOT VACUUM
Front sensor, edge IR sensor or cliff sensor is
dusty. Please clean it.
Cliff sensor may be attached to foreign matter
or dirt. Please clean and move it to a new
position to start it.
The radar on the top tower is blocked and
routing fails. Remove blockage.
Dust box is full. Please empty it.
The robot is at a virtual wall or forbidden area.
Please move it out of the area.
The robot is trapped by obstacle around it.
Please remove any obstacle.
The robot fails to locate base. Place it manually
back onto the base.
The robot is in a new environment and no map
is created yet. Please re-start vacuuming task.
24