Installation - Wilfa Innobot Rvc-D4000Sl Anleitung

INNOBOT · RVC-D4000SL+, RVC-D4000SL, RVC-D4000AI

INSTALLATION

To install the charging station, place it against the wall, and connect the power
cord. Make sure there is enough space in front and on the sides of the charger.
To install the auto-empty station. Place the dustbin against the wall and connect
the power cord.
Note:
• Do not place the charger in direct sunlight.
• The auto-empty station requires more than 1.5-meter space in front and
more than 0.5-meter space on both sides.
• Make sure the power cord is not placed where the robot can drag it.
POWER ON AND CHARGE
Put the robot on the base and align the charging electrodes with charging
contact. For daily use, you can start intelligent recharge by short pressing the
button
• Robot can't start up when it has low power. Please put it on the base to
recharge.
• Robot will start up automatically after connecting to the base and can't be
shut down while recharging.
SWEEPING MODE
Open the cover, insert the dust box and press it down.
Note: Clean the dust box regularly in case of the dirt affecting the cleaning
effect.
15
EN