Main Brush - Wilfa Innobot Rvc-D4000Sl Anleitung

Note: It is recommended to replace the side brush every 3-6 months to ensure
the cleaning effect.
EN

MAIN BRUSH

1. Turn the robot over, press and hold the two release buttons to remove the
main brush cover.
2. Take out the main brush upwards.
3. Use the knife on the cleaning brush to cut the entangled hair on the main
brush and clean the main brush.
4. Put back the main brush and the main brush cover, and press the main brush
cover to install it in place.
Note: It is recommended to replace the main brush every 6-12 months to ensure
the cleaning effect.
BRUSH CLEANING METHOD
Use the included cleaning tool.
Cut hair
CLIFF SENSOR
Use a soft dry cloth to clean the cliff sensor every 3 months.
Cliff sensor
INSTRUCTION MANUAL · ROBOT VACUUM
Main brush cover
Release keys
Main brush
Clean the dirt
20