Ventilation System - Nolan N405 Sicherheit Und Gebrauchsanleitung

N40-5
WARNING
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet before completely and correctly reassembling its inner com-
fort padding.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
- Rinse with cold water and allow drying at room temperature, away from direct
sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the helmet's internal polystyrene components in any way.
- Clean the inner components with a damp cloth only and allow it to dry at room
temperature away from direct sunlight.
- Never use tools or equipment of any sort to carry out the steps described above.

VENTILATION SYSTEM

The ventilation system of the N40 helmet consists of:
5
Front Air Intake
The innovative AIRBOOSTER TECHNOLOGY channels the air coming from the front
air intake by directing it in the top area of the rider's head without any dispersion. The
front air intake (Fig. 18) can be completely or partially opened depending on whether
its slider is pulled completely backwards (A). To close the front air intake, pull the above
mentioned slider completely forward (B).
Rear Extractors
Are integrated in a rear spoiler and allow warm and stale air to flow out ensuring an
optimum comfort inside the helmet. (Fig. 19).
N-COM - NOLAN COMMUNICATION SYSTEM PRE-SETTING
Your helmet is factory-preset to be equipped with the N-Com communication system.
If your helmet is homologated according to ECE/UN Regulation No.22, it has also been
tested and homologated with the N-Com system installed. Installing a system other
than the N-Com affects the helmet's regulatory compliance.
During the communication system installation (see the specific instructions contained
in the N-Com kit), it will be necessary to remove from the helmet the foam material fillers
located in the polystyrene cheek pads next to the N-Com earphones seats.
The above-mentioned fillers should only be removed if the helmet is used with a
compatible N-Com system installed.
20
INSTRUCTIONS FOR USE
N40-5
21
INSTRUCTIONS FOR USE