Ventilation System - Nolan N702 X Sicherheit Und Gebrauchsanleitung

2 DISASSEMBLING THE SIDE PLATES
To disassemble the side plates first remove peak, if assembled (see instructions above).
2.1 Pull the front part of the plate towards the external of the helmet to release the low-
er hook "A" and the top hook "B" from the corresponding seats in the mechanism
(Fig.29).
2.2 Follow the previous operations on the right side of the helmet.
WIND PROTECTOR
(Available as standard or accessory/spare part)
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig.30 for assembly and disassembly operations.

VENTILATION SYSTEM

The ventilation system of the helmet consists of:
Lower ventilation system
It allows ventilation in the mouth area and conveys the air directly on the visor reducing
fogging.
See Fig.31 for opening and closing operations.
Top Ventilation System
The innovative AIRBOOSTER TECHNOLOGY system channels the air flowing in from
the front air intake, directing it to the top area of the user's head without any dispersion.
See Fig.32 for opening and closing operations.
Rear ventilation system
It allows warm and stale air to flow out ensuring an optimum comfort inside the helmet
(Fig.33).
SETTING UP THE N-COM - NOLAN COMMUNICATION SYSTEM
(Available depending on the product version)
Your helmet is factory-preset to be equipped with the N-Com communication system.
When installing the communication system (see the specific instructions contained in
the N-Com kit), you need to remove the lower back rest and the foam material fillers,
present in the polystyrene cheek pads at the N-Com earphones seats, from the helmet.
The lower back rest and the above mentioned fillers should be removed only when
using the helmet with a compatible N-Com system installed.
N70-2 X
27
INSTRUCTIONS FOR USE