ZAPTEC Pro Installationsanleitung Seite 16

English
The charging
station is placed
correctly on the
back plate.
There is a gap
between the
charging station
and the back plate.
16
4
Position the charging station on the back plate
NB: Verify that there is no gap between the charging station
and the back plate. If there is a gap you may have used
incompatible screws to attach the back plate to the wall
(check step 1 of installing backplate).
5
Tighten the nuts
Tighten the charging station using the four supplied nuts.
The nuts must be tightened to a torque of 3 Nm.
x 4
J Mounting nuts – ZB100049
6
Fit the front cover
Ensure that the cover for the status indicator (Z) is
correctly positioned before replacing the front cover again.
In order to replace the front cover, you must first position
the cover over the Type 2 port and then attach it to the
charging station.