ZAPTEC Pro Installationsanleitung Seite 10

English
Add charging circuits to the installation
• Once the installation has been set up, press the "Circuits" tab
• Click on "Add circuit"
• Enter the circuit designation stated on the circuit breaker
• State the value A] for overload protection
Charging stations that receive power from this charging circuit can charge
up to the value of the charging circuit. You may wish to specify a lower value
to limit the maximum circuit current.
Add charging stations to the installation
After you have created the installation in Zaptec Portal, create circuits in
accordance with the electrical installation at the location. The charging
stations must then be added to the associated circuits.
Fill in the serial number (ZPRxxxxxx) and the name of each charging station.
The name should be the charging station's owner, apartment number,
parking space number or some other physical identification for the exact
location of the charging station. The location of the serial number is shown in
the illustration. Charging stations illuminate green when they are online.
The installation in the Zaptec Portal must represent the physical installation
at the location. The Zaptec Portal installation is a virtual installation in order
to balance load and phase algorithms in the charging system.
10
Serial number,
e.g. ZPR123456