Operation; Start And Stop; Operating; Starting A Cut - Atlas Copco TEX 09PS Sicherheits- Und Betriebsanleitung

TEX 09PS, 10PS, 12PS
TEX 09PS, TEX 10PS, TEX 12PS
1. Place the cap over the body of the insertion tool.
2. Place the buffer (A) over the stem of the insertion
tool.
3. Insert the insertion tool into the cylinder and
screw the cap onto the cylinder until it is locked.
A
TEX 09PS KL, TEX 10PS KL, TEX 12PS KL
1. Fit or remove the insertion tool.
2. Close the tool retainer (position A).

Operation

WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
Learn how the machine is switched off in the event
►
of an emergency.
► Stop the machine immediately in all cases of
power supply interruption.
© 2013 Atlas Copco Construction Tools AB | No. 9800 1386 90 | 2013-04-15
Original instructions
A
Safety and operating instructions

Start and stop

TEX 09PS, TEX 10PS
Start the machine by squeezing the trigger while
firmly holding the handle.
TEX 09PS, TEX 10PS
Stop the machine by releasing the trigger. The trigger
returns automatically to the stop position.

Operating

Starting a cut

Stand in a stable position with your feet well away
♦
from the inserted tool.
Press the machine against the working surface
♦
before you start.
Start collaring at such a distance from the edge
♦
that the machine is capable of breaking the
material without levering.
Never try to break off too large pieces. Adjust the
♦
breaking distance (A) so that the inserted tool does
not get stuck.
TEX 12PS
TEX 12PS
A
17