Noise Level Label; Safety Label; Eject Warning Label; Installation - Atlas Copco TEX 09PS Sicherheits- Und Betriebsanleitung

TEX 09PS, 10PS, 12PS
The warning symbol together with the book
D.
symbol means that the user must read the
safety and operating instructions before the
machine is used for the first time.
E. The CE symbol means that the machine is
EC-approved. See the EC declaration which
is delivered with the machine for more
information. If the CE symbol is missing, it
means that the machine is not EC-approved.

Noise level label

WA
xxx
dB
The label indicates the guaranteed noise level
corresponding to EC-directive 2000/14/EC. See
"Technical data" for accurate noise level.

Safety label

To avoid injury, before using or servicing tool, read
and understand separately provided safety
instructions.

Eject warning label

The label indicates that the machine must be
disconnected from the power source before removing
or changing the inserted tool.
© 2013 Atlas Copco Construction Tools AB | No. 9800 1386 90 | 2013-04-15
Original instructions
Safety and operating instructions

Installation

Hoses and connections

A
B
Compressed air source
A.
Water separator (optional)
B.
C. Lubricator (optional)
Max. 3 m (10 ft) compressed air hose between
D.
the lubricator and the machine.
Check that you are using the correct
♦
recommended operating pressure, 6 bar (e) (87
psi).
The maximum permissible air pressure, 7 bar (e)
♦
(102 psi), must not be exceeded.
Blow any impurities out of the compressed air hose
♦
before connecting it to the machine.
Select the correct dimension and length for the
♦
compressed air hose. For hose lengths up to 30
m (100 ft), a hose with a minimum internal
diameter of 19 mm (3/4 in.) must be used. If the
hose length is between 30 and 100 m (100 and
330 ft), a hose with a minimum internal diameter
of 25 mm (1 in.) must be used.

Methods to prevent freezing

Ice formation in the silencer can occur when the
ambient air temperature is 0–10°C (32-50 °F) and
the relative humidity is high.
The machine is designed to avoid the formation of
ice in the silencer. Despite this, under extreme
conditions ice can form in the silencer.
Take the following actions to further counteract the
risk of ice formation:
Use Atlas Copco Breaker and hammer AIR-OIL
♦
as a lubricant. Breaker and hammer AIR-OIL
counteracts freezing.
Use a water separator.
♦
D
C
15