Bosch MUM58M59 Gebrauchsanleitung Seite 28

en Operation
Warning!
The continuous­feed shredder must be com­
pletely assembled before use. Never assem­
ble the continuous­feed shredder on the base
unit. Operate the continuous­feed shredder in
the indicated operating position only.
Predetermined breaking point
Fig. F:
The built­in predetermined breaking point
protects the drive of the appliance. If an
overload occurs, the drive shaft of the con­
tinuous­feed shredder breaks. However, the
drive shaft can easily be replaced. A new
disc holder with drive shaft is available from
customer service.
Reversible slicing / shredding
disc
for grating raw potatoes or cutting into
slices.
Note: Not suitable for processing very
fibrous foods, e.g. leek or mango.
Reversible shredding disc –
coarse / fine
for shredding food coarsely or finely, e.g.
fruit, vegetables or cheese as Gouda or
Edam.
Marking:
■ 2 = coarse side
■ 4 = fine side
Note: Not suitable for processing nuts or
hard cheese, e.g. Parmesan.
Tip: Shred soft cheese with the coarse side
only.
Fine grating disc
for shredding food finely, e.g. nuts
or hard cheese such as Parmesan.
Note: Not suitable for processing soft
cheese and cheese slices.
Grating disc coarse
for grating raw potatoes, e.g. for
potato pancakes or dumplings.
Asia vegetables disc
for cutting food into thin strips, e.g.
fruit and vegetables.
28
Working with the continuous-feed
shredder
Fig. G:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti­clockwise until it locks
into place.
■ Press the Release button and
move the swivel arm to
position 3.
■ Remove drive cover from the
drive of the continuous­feed shredder
(Fig. G-5a).
■ Hold disc holder at the lower end, ensur­
ing that the two tips are face up.
■ Carefully place the required slicing or
shredding disc onto the tips of the disc
holder (Fig. G-6a).
In the case of reversible discs, ensure
that the required side is face up.
■ Grip disc holder at the upper end and
insert into the housing (Fig. G-6b).
■ Attach the cover (note mark) and turn all
the way in a clockwise direction.
■ Place continuous­feed shredder on the
drive and rotate all the way in a clock­
wise direction, as illustrated in Fig. G-8.
■ Turn rotary switch to recommended
setting.
■ Put food to be processed in the feed
tube and push down with the pusher.
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in
the continuous­feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuous­feed shredder
and empty feed tube.