Before use
WARNING! RISK OF INJURY!
►
Always remove the plug from the power
socket before working on the appliance.
Fitting the magazine attachment
♦
Insert the screw bit
holder
.
♦
Push the magazine attachment
screw bit
as far as the stop on the appliance.
NOTE
►
To make your work easier, you can also fit
the magazine attachment
of 45°.
Inserting the screw belt
♦
First pull the screw belt
belt guide
.
♦
Then guide the screw belt
guide
until the screw belt
audible snap-in point. Ensure that the last empty
slot before the first screw is positioned directly in
front of the screw bit
■
When pressure is applied, the screw belt
moved on and then the first screw is positioned
in front of the screw bit.
Fitting the depth stop sleeve
♦
Insert the screw bit
adapter
and then into the tool holder
♦
Push the depth stop sleeve
bit
and the bit adapter
on the appliance.
■
6
│ GB│IE│NI│CY
(150 mm) into the tool
over the
offset by steps
through the lower
into the upper belt
reaches the first
.
is
(25 mm) into the bit
.
over the screw
as far as the stop
Use
WARNING! RISK OF INJURY!
►
Always remove the plug from the power
socket before working on the appliance.
Switching on and off
During operation, you can choose between in-
stantaneous and continuous operation. Select the
required operation mode as follows:
Switching to instantaneous operation:
♦
Press the ON/OFF switch
Switching off instantaneous operation:
♦
Release the ON/OFF switch
Switching to continuous operation:
♦
Press the ON/OFF switch
in and then press the lock button
Switching off continuous operation:
♦
Press the ON/OFF switch
Setting the rotation direction
♦
Change the direction of rotation by pressing
the rotation direction switch
or right.
WARNING!
►
The direction of rotation may only be
changed when the device is at a standstill.
Adjusting the rotational speed
You can use the rotation speed preselector adjusting
wheel
to preselect the rotational speed in preset
steps:
(− = slower speed, + = faster speed).
We recommend you carry out practice tests to
determine the correct speed.
The speed can also be changed during operation.
.
.
, keep it pressed
.
and then release it.
towards the left
PTBS 520 A1