Using the magazine attachment
Setting the screw length:
♦
Undo the screw
.
♦
Set the required screw length using the screw
Position the locking tab in the provided slot for
the required screw length.
♦
Retighten the screw
35
25
40/41
30
Setting the screw-in depth:
♦
Set the required screw-in depth using the
screw
.
■
You can work out the required screw-in depth
by trial and error.
Surface
Level
NOTE
►
Check the direction of rotation before starting
work. The magazine attachment
only be used when the direction is set to
"clockwise" (see section "Setting the rotation
direction").
Screwing in screws:
♦
Always apply the magazine attachment
the workpiece at right angles. The screw stop
must be over the screwing location.
♦
Switch on the device on switch
♦
Apply even pressure to the workpiece until the
screw is screwed in.
♦
Raise the screw stop
back to its starting position. The next screw is
transported into the working position when it is
actuated again. As soon as the screw-in depth
is reached, the drive disengages and the screw
bit
stops turning.
PTBS 520 A1
.
may
to
.
briefly so that it jumps
NOTE
►
Screws which have already been screwed in
cannot be unscrewed or tightened with the
magazine attachment
.
To do this, remove the magazine attachment
and use the depth stop sleeve
Using the depth stop sleeve
The depth stop sleeve
the screw-in depth of screws.
Setting the screw-in depth:
♦
Turn the adjusting ring
your working position) to reduce the screw-in
depth.
♦
Turn the adjusting ring
from your working position) to increase the
screw-in depth.
■
You can work out the required setting by trial
and error.
Screwing in screws:
♦
Place the screw bit
on the screw.
♦
Press the screw against the workpiece.
♦
Switch the appliance on.
♦
Screw the screw into the workpiece until the
preset screw-in depth is reached.
As soon as the screw-in depth is reached, the
drive disengages and the screw bit
turning.
♦
Check the screw-in depth.
fitted.
.
allows you to determine
clockwise (seen from
anticlockwise (seen
and the bit adapter
stops
GB│IE│NI│CY │
7
■