Service; Device-Specific Safety Instructions For Magazine Attachments/Screwdrivers - Parkside PTBS 520 A1 Originalbetriebsanleitung

b) Do not use the power tool if the switch does
not turn it on and off. Any power tool that can-
not be controlled with the switch is dangerous
and must be repaired.
c) Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are dan-
gerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tool's operation. If damaged, have the
power tool repaired before use. Many acci-
dents are caused by poorly maintained power
tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation.

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
PTBS 520 A1
Device-specific safety instructions for
magazine attachments/screwdrivers
■
Hold the appliance by the insulated handles
when you are carrying out work during which
the screws may come into contact with con-
cealed power cables or the tool's own power
cable. If a screw comes into contact with a live
wire, this may make exposed metal parts of the
power tool live and could give the operator an
electric shock.
■ Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments or changing
accessories. Unintentional starting of power
tools is the cause of many accidents.
■ Hold the power tool firmly. High reaction
moments can occur for brief periods while
tightening and loosening screws.
■ Secure the workpiece! A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand.
■ Wait until the power tool has come to a stand-
still before putting it down. The tool can jam,
this leading to loss of control of the power tool.
■ Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewel-
lery or long hair can be caught in moving parts.
■ Never point the power tool at yourself or
other people in the vicinity.
■ Never reach into the magazine attachment or
the screwing location during work. There is a
risk of personal injury from sharp-edged screws
or due to crushing.
■ Only use suitable screw belts as described
in the technical data. Using other screws can
damage the magazine attachment.
GB│IE│NI│CY │ 5 ■