Set-Up; General; Initial Inspection; Reels - Jacobsen 67963 – LF 4677 Handbuch

3

SET-UP

3.1

GENERAL ________________________________________________________________

The set-up and testing of the unit should always be
performed by a trained technician, familiar with the
operation of this equipment.
Read each instruction completely and make sure you
understand it before proceeding with the assembly. Stay
alert for potential hazards and obey all safety
precautions.
The RIGHT and LEFT, FRONT and REAR of the
machine are referenced from the operator's seat, facing
forward.
3.2

INITIAL INSPECTION _______________________________________________________

T he intial inspection should be performed only when the engine is off, and all fluids are cold. Lower implements to
the ground, engage parking brake, stop engine, and remove ignition key.
1. Perform a visual inspection of the entire unit, look for
signs of wear, loose hardware, and components that
may have been damaged during transport.
2. Inspect paint and decals for damage or
Decals provide important
information. Replace all missing or hard to read decals.
3. All fluids must be at the full level mark with engine cold
Check :
a. Radiator coolant level.
b. Engine oil level.
c. Hydraulic fluid level.
3.3

REELS ___________________________________________________________________

1. If installing five inch reels, apply Moly EP grease to
female spline on reel, and insert reel coupler (N) into the
bearing housing before attaching reel motor.
2. Remove hardware (P) from the outside front roller
brackets of the front wing mowers only. Install skid
plates (R) as shown using four 5/16-18 x 1 in. hex
head screws (S), four 5/16-18 Spiralock flange nuts
(T), two washers (U), and hardware (P).
!
CAUTION
scratches.
operaing and safety
Accessories not included with this product must be
ordered separately. See instructions provided with
accessory for installation and parts.
!
CAUTION
Do not attempt to drive the mower unless you are
familiar with this type of equipment and know how to
operate all controls correctly.
4. Make sure air filter connections are tight and cover is
securely in place.
5. Check tires for proper inflation. Tires have been over
inflated for transport. Correct tire pressure should be
set to 10 psi.
6. Check belt tension.
[Section 4.8]
7. Inspect battery connections and electrolyte level.
Check that battery is fully charged.
8. Check for fuel or oil leaks.
1. Inspect lube points on reels and mower for proper
lubrication.
[Section 6.1]
T
SET-UP
N
R
S
P
U
Figure 3A
en-13
3