Set-Up 3.1 General; Initial Inspection; Reel Motors - Jacobsen Greens King IV Handbuch

3 SET-UP
3 SET-UP
3.1 GENERAL________________________________________________________________
The set-up and initial testing of the unit should always be
performed by a trained technician, familiar with the
operation of the equipment.
Read Each instruction completely and make sure you
understand it before proceeding with the assembly. Stay
alert for potential hazards and obey all safety
precautions.
The RIGHT, LEFT, FRONT and REAR of the machine are
references from the operator's seat facing forward.
3.2

INITIAL INSPECTION_______________________________________________________

!
CAUTION
The daily inspection should be performed only when
the engine is off and all fluids are cold. Lower mowers
to the ground, engage the parking brake, stop engine,
and remove ignition key.
1. Perform a visual inspection of the entire unit, look for
signs of wear, loose hardware, and components that
may have been damaged during transport.
2. Inspect paint and decals for damage or scratches.
Decals provide important safety and operating
information. Replace all missing or hard to read
decals.
3.3

REEL MOTORS ___________________________________________________________

1. Remove hardware from each of the mounting studs
on the housing and remove cover plate (Not shown).
2. Move cutting unit to corresponding location and
assemble motor to housing with hardware removed
in Step 1. Gasket (A) must be between motor and
housing.
10
Accessories not included with this product must be
ordered separately. See instructions provided with
accessory for installation and parts.
3. All fluids must be at the full level mark with engine
4. Make sure air filter connections are tight and cover
5. Check tires for proper inflation. Tires have been
6. Check for fuel or oil leaks.
7. Check lube points on reels and tractor for proper
A
Figure 3A
!
CAUTION
Do not attempt to drive this tractor unless you are
familiar with this type of equipment and know how to
operate all controls correctly.
cold.
Check:
a. Engine oil level
b. Hydraulic fluid level
is securely in place.
over inflated for transport. Correct tire pressure
should be set to 10 psi.
lubrication.