Additional Base Stations - AUDIOLINE DECT 5500 Bedienungsanleitung

8.6

Additional base stations

A number of base stations can be used to extend the coverage available to the handsets.
To make use of this effect, all the base stations must have a telephone connection.
Depending on your objectives, you can provide each base station with its own telephone
line or connect them all to the same line. A new number will be allocated to the handset
each time that it moves within range of another base station.
You should ensure that the coverages of the base stations overlap. Before adding a new
base station to your system, check the range of the handsets.
If a handset is registered with the base station and automatic base station selection is
switched on (further information in this chapter), the handset will be automatically
handed on to the next base station. Calls in progress cannot be passed from one base
station to another.
Selecting a base station
1. Press the
2. Use and
3. Use and
4. Use and
handset automatically switches to the next base station. If the handset is
registered with the base station concerned, a small rectangle is shown after
the number. Only these base stations can be selected.
5. Press the
6. The OK prompt will appear in the display. You can now complete de-
registration by pressing the
the button down. If de-registration is completed, a beep will be heard after a
few seconds. The handset is now de-registered and can no longer be used
with this base station.
- Several Handsets -
button on the handset.
to select the SETUP menu, then press
to select the SEL BASE menu, then press
to select the desired base station. If AUTO is selected, the
button again.
or cancel the de-registration by holding
.
.
65