Making Calls; Length Of Call Display; Turning The Handset On And Off; Range Indications - AUDIOLINE DECT 5500 Bedienungsanleitung

3.3

Making calls

1. Use the key pad to enter the desired telephone number. Up to 25 digits may be
entered. The digits pressed will be shown in the display. Since the display can only
show 12 digits, only the last 12 of long phone numbers will be shown.
Notice: If you make a mistake you can briefly press the
a time. If the
2. Press the call button,
Notice: You can also press the call button,
you enter the digits of the desired number, your AUDIOLINE DECT5500 will send them
straight out. The correction of individual digits as described above is not possible in this
case.
3.4

Length of call display

During a call, the duration of the call is displayed in minutes and seconds. 15 seconds
after dialling, the display changes from the number called to the length of call. The
length of call display persists for a few seconds after ending the call.
3.5

Turning the handset on and off

By holding down the menu key,
turned off, there is no drain on the battery. You cannot make or take calls.
Press the menu key,
displayed and the handset will be ready for use after a brief delay.
3.6

Range indications

The range of the handset is about 50 metres in enclosed areas and about 300 metres in
the open. If a good connection to the base station is available, a
the display.
If you move too far from the base station, the
warning peeps. In this case you should move closer to the base station to avoid loosing
the connection. These warning peeps can be turned off as described in chapter 7.9.
- Normal Use -
button is held down, the entire number will be deleted.
,
on the handset to place the call.
, briefly to turn the unit back on. The message, BASE, will be
,
first; you will then hear the dial tone. As
,
you can turn off the handset. If the handset is
symbol will blink and you will hear
button to delete one digit at
symbol will appear in
45